Keeguard Standing Seam

KeeGuard Standing Seam Railing is an OSHA Compliant roof edge fall protection system that prevents workers and other personnel from falling off of the roof. Metal plates clamp onto the standing seam using S5U aluminum clamps. Railing posts are bolted to the plate, and top and mid rails are installed between the posts. The railings extend above the walking surface 42” and withstand a force of 200 pounds. Its configuration accommodates varying angles, circular configurations, ladders and rooftop obstructions. KeeGuard Standing Seam Railing System complies with OSHA Standards 29 CFR 1910.23 and meets North American and Canadian requirements. 

OSHA compliant design
Clamps to Standing Seam roofs without roof penetrations
Accommodates varying angles, ladders and rooftop obstructions
Custom fabricated base plates accommodate any standing seam width
Kick plates are available
Posts, top and mid rail pipes are ASTM A53 1-1/2-inch schedule 40 galvanized steel
Fittings are KeeKlamp galvanized to ASTM A53 requirements
Mounting bases are galvanized steel utilizing S5U aluminum clamps
Finish for pipe, handrails, mid-rails, uprights and baseplates are a galvanized mill finish to ASTM A53 requirements
Kee Klamp type 69 base fitting used when toe plates are required

Four S5U clamps are bolted to galvanized steel base plates
S5U clamps and base plate assembly is attached to the standing seams
Kee Klamp type 62 base fitting is attached to each metal base plate to support the galvanized upright posts assemblies
Upright post assemblies are installed
Galvanized top and mid railings are installed from post to post
Note: 3 workers can install greater than 300 linear feet of railing in a day. Shop drawings can be provided if needed.